universalblue UBHC3-18 Manual De Instrucciones página 57

When the oven is connected to the power, "0.00" and "AUTO" flash
on the screen.
• Press Button 1 for approximately 1 second; the dot icon will begin
to flash. Use buttons 2 and 3 to set the time. About 7 seconds
after the time has been set, the time setting ends.
• When you need to set the time again, press buttons 2 and 3 for
approximately 1 second; the dot icon will begin to flash. Set the
time again.
Warning! If you do not set the time, you cannot use the oven
functions.
Alarm timer
The timer alarm can be activated independently of other programs.
It can be set from 1 minute to 23 hours and 59 minutes.
To configure the alarm, follow the following instructions:
• Press Button 1 until the alarm timer icon starts blinking; "0.00"
will appear on the screen.
• Use buttons 3 and 2 to set the required time. The alarm timer
icon will be displayed until the time expires.
• When the timer expires, an alarm will sound for approximately 7
minutes and the alarm timer icon will begin to flash again.
• The alarm stops when buttons 1, 2 or 3 are pressed. At this time
the alarm icon will disappear and the time will be displayed on
the screen.
If you want to change the tone of the alarm using buttons 2 or 3.
•
Pressing button 1 the current sound 'ton.1' will appear on the
screen. Press the 2 or 3 button to select the 2 or 3 sound.
To cancel the set time:
• If you have used the automatic function, press buttons 2 and 3.
• If you have used the timer alarm, press button 1 first to select the
alarm and then press buttons 2 and 3.
Schedule end time
57