Husqvarna LP 6500 Manual De Usuario página 10

3. Pull the starter rope until the engine starts.
To start the product with electrical start
Do this procedure if the product has an engine with
electrical start.
1. Make sure that the vibration control (A) is in the OFF
position.
A
B
2. Make sure that the control for forward and rearward
movement (B) is in the neutral position.
10
3. Set the battery switch in the ON position.
4. Turn the ignition key to the ignition position.
a) When the engine starts, immediately release the
ignition key. The ignition key goes to the neutral
position.
b) If the engine does not start in 20 seconds,
release the ignition key and wait 60 seconds
before you try again.
5. Let the engine operate at idle speed for 2–3 minutes.
1503 - 002 - 15.07.2022