Husqvarna LP 6500 Manual De Usuario página 9

• Do the daily maintenance. Refer to
schedule on page 11 .
To set the handle to operation position
WARNING:
when you change the position of the handle.
There is a risk of injury if the handle falls on
you.
1. Hold the handle.
2. Release the lock lever and lower the handle
carefully.
To adjust the handle height
• Adjust the handle height with the vibration damping
units for the handle.
1503 - 002 - 15.07.2022
Maintenance
Hold the handle tightly
a) Turn the screws for the vibration damping units
to adjust the handle height.
CAUTION:
same height to make sure that the load
on the handle is balanced.
To start the product manually
Do this procedure if the product has an engine with
manual start.
1. Make sure that the control for forward and rearward
movement (A) is in the neutral position.
B
A
2. Make sure that the vibration control (B) is in the OFF
position.
Adjust the screws to the
9