Consignes De Sécurité - HammerSmith 234820 Instrucciones De Uso

3. Switch on the tool and slowly bring the saw blade into contact
with the workpiece at the desired starting point.
Cutting sheet metal:
1. Clamp a piece of plywood or soft wood to the rear side of the
workpiece and saw through both materials in order to achieve
a clean cut.
2. Do not use force to aid the saw blade in penetrating the
workpiece. Note that the process of sawing sheet metal usually
longer than for thick pieces of wood.
3. Apply a thin film of oil along the cutting line before you start
sawing.
4. To cut, turn on the tool and slide it down until the saw blade is
situated just above the entry point. Lower the rear part of the saw
shoe against the workpiece, while alternating regular pressure
between it and the saw shoe. With the saw shoe resting directly on
the workpiece, insert the saw blade into the workpiece.
Cutting laminates:
1. Cut thin laminate with the rear side facing upwards, as chipping
when sawing workpieces usually occurs on the side facing the
saw shoe.
2. To get a clean cut, we recommend sandwiching the laminate
material between pieces of plywood or hardboard on both sides,
and sawing through the combination of materials.
SPECIFICATIONS:
n : 0 - 2,300 rpm
0
Motion length 14 mm
Weight 0.52 kg (1.53 kg multi-functional tool with battery pack)
Sound pressure level Lpa: 82 dB - relative fuzziness Kpa: 3 dB,
sound power level Lwa: 93
dB - relative
Fuzziness Kwa: 3 dB,
Vibration emission value ah, , B = 5.63 m/s2 - uncertainty k = 1.5
m/s2, ah, M = 4.34 m/s2 -
uncertainty k = 1.5 m/s2
This product complies with the European
directives.
Lisez attentivement ces instructions d'utilisation avant
d'utiliser cet appareil ! Veuillez suivre les consignes de
sécurité dans leur intégralité afin d'éviter tous dommages
liés à une mauvaise utilisation ! Conservez ces instructions
d'utilisation pour pouvoir les consulter ultérieurement. Dans
le cas où cet appareil devait être cédé à un tiers, cette notice
doit également lui être remise.
CONSIGNES DE SÉCURITÉ
1. SÉCURITÉ SUR LE POSTE
DE TRAVAIL
• Maintenez toujours votre
poste de travail propre et
bien éclairé. Les postes de
travail désordonnés et mal
éclairés augmentent le risque
d'accidents.
• N'utilisez pas l'appareil
à proximité de liquides
inflammables, gaz, poussière
ou zones à risque d'explosion.
L'appareil peut émettre
des étincelles qui peuvent
Made in China
FR