Important; Introduction; Safety Instructions - Schulz MIS 100 Manual De Instrucciones

IMPORTANT

TIONS must be observed to reduce the risks and prevent personal or material damage to your equipment.

2. INTRODUCTION

MAKE SURE TO READ AND FULLY UNDERSTAND THE INFORMATION CONTAINED IN THIS MA-
NUAL BEFORE OPERATING YOUR ELECTRICAL EQUIPMENT.
The welding inverter is a power source with IGBT technology, which provides greater precision in the control of
the welding current and a voltage compensation system, resulting in a subtle electric arc, with little spatter and,
consequently, a weld with greater homogeneity.
The equipment's working factor refers to the operating time at maximum current, considering a time interval of
10 minutes. In other words, the SCHULZ models have a 40% working factor, therefore, it is capable of operating
at maximum current for 4 minutes, requiring a 6-minute break to cool the equipment before starting a new job.

3. SAFETY INSTRUCTIONS

1.
The tool must not be used by children or people unfamiliar with its use;
2.
Do not use the equipment barefoot, in wet or very humid places, as this increases the risk of electric
shock;
3.
For protection against electric shock, it is recommended to install a residual current circuit
breaker. Consult an electrician to select and install this safety device;
4.
To reduce the risks of electric shock, when using your equipment, do not touch metal surfaces
attached to the ground or grounded, such as pipes, motors, gutters, fences, windows, doors, metal
gates, etc;
5.
Do not make splices in the cord. If required, ask for a power cord replacement at the nearest
Schulz Authorized Dealer ;
6.
Do not use your equipment while tired, under the influence of medication, alcohol or drugs. Lack of
attention during operation may result in serious personal injury;
7.
Always use suitable personal protective equipment (PPE), such as dust glasses and masks, non-skid
safety shoes and ear protection. This reduces the risks against personal injury;
When using this product, basic safety precautions described in the SAFETY INSTRUC-
29
ENGLISH