Edge Guide - Truper ROU-MN Manual

Operation
Copying guide
• Use a template (A) between the router base (B) and the
workpiece (C).
• Rest the copying guide bushing (D) on the edge of the
template.
• Make the cut without separating the bushing around the
perimeter of the template (E).

Edge guide

• Rest the edge guide roller (F) on the edge of the
workpiece (G).
• Make the cut without separating the roller around the
perimeter of the workpiece.
CAUTION • Before cutting,
test a scrap piece to determine the
position of the roller. Tighten the
knobs before cutting.
Drill bits with guide stop
• Drill bits with built-in stops are ideal for working edges.
The workpiece itself can serve as a guide when its
thickness is greater than the height of the drill bit (I). If the
thickness of the work piece is less than the height of the
drill bit, use a guide (K) to make the cut.
I
D
F
K
A
B
A
C
G
D
E
F
ENGLISH
13