Set Up - Truper ROU-MN Manual

Set up

Disassembly and assembly of the cylinder
• The router motor is housed in the vertical cylinder (A)
which raises or lowers inside the fixed base (B) to adjust
the drill bit to the proper height for the work to be
performed.
CAUTION • Before installing a drill bit or changing
the collet or clamp, the cylinder must be removed from
the fixed base.
CAUTION • Before disassembling or assembling
the cylinder, turn off and disconnect the router from the
power supply.
• To remove the cylinder, release the lever (C) from the
fixed base clamp.
• Lift the motor head (D) until the cylinder is removed
from the fixed base.
• To reassemble the cylinder, make sure to align the
toothed groove (E) with the base sprocket (F).
• Insert the cylinder into the fixed base.
• Push the lever (C) to close the clamp.
Drill bit installation or disassembly
CAUTION
• Before installing or removing a drill bit,
turn off and disconnect the router from the power source.
You can perform drill bit installation and demounting in two
ways:
1. By removing the cylinder.
• Remove the cylinder (A) from the fixed base as described
in the previous section and rest the motor head on a flat
surface with the cylinder pointing up.
• Depress the shaft lock (G) to prevent the shaft from
rotating.
• Without releasing the shaft lock, loosen the collar nut (H)
with the 7/8" wrench ( I ).
• Place the drill bit ( J ) in the collet, the shank must enter at
least 19/32" to ensure that the drill bit does not accidentally
come out.
• Tighten the collet nut firmly with the wrench to secure the
drill bit.
• Release the spindle lock (G) and make sure that the drill
bit is securely in place.
• To remove the drill bit, depress the spindle lock and
loosen the collet nut with the wrench provided.
2. Without removing the cylinder.
• Remove the drill bit as explained in the previous section.
• Use the 1/2" wrench (K) to secure the shaft to prevent it
from turning.
• Hold the collar (H) with the 7/8" wrench ( I ) and turn the
nut counterclockwise.
• Place the 7/8" wrench on the collar and the 1/2" wrench
on the motor shaft.
• Hold the 1/2" wrench and loosen with the 7/8" wrench.
• Place the drill bit in the collet the shank must go in at least
19/32" to ensure that the drill bit does not accidentally come out.
• Replace the 1/2" wrench and tighten firmly with the 7/8" wrench.
• To remove the bit, follow the reverse of the installation procedure.
D
F
I
Tighten
Loosen
A
E
C
J
B
H
G
A
H
K
ENGLISH
I
7