Truper ROU-MN Manual página 8

Splinter shield assembly
• Attach the chip cover (also vacuum port) (A) to the
front of the router base.
• To secure it in place, tighten the knob (B).
CAUTION
• The cover must be mounted and
secured before operating the router.
• Depending on the work to be performed, the router
accepts different types of auxiliary guides: parallel
guide, edge guide or copying guide.
Parallel guide installation
• Slide the parallel guide slot (C) into the screw on the
back of the router and secure it in place by tightening
the knob (D).
Edge guide installation
• Slide the edge guide slot (E) into the screw on the
back of the router and secure it in place by tightening
the knob (D).
Assembly of the copying guide
• Loosen the screws and remove the base protector (F).
• Put the copying guide (G) on the base and replace the
base protector. Then fasten the base protector by
tightening the screws.
8
ENGLISH
Set up
A B
C
E
F
G
D
D