Sauder 430621 Instrucciones De Ensamblaje página 10

Step 7
å
NOTE: The unit can be positioned horizontally or vertically.
å
Carefully stand your unit upright against the wall in its final location. If you are standing your unit horizontally, the
SAFETY STRAP is not needed.
å
NOTE: The following instructions show your vertical unit being fastened to a wall stud. If you are not fastening your unit
to a wall stud, go to the next step now.
å
1 - Locate the center of a stud in your wall near your unit and mark it with a pencil just below the top surface of your
st
unit so the SAFETY STRAP will not be visible.
å
2 - Drill a 1/8" hole on the mark and into the stud in your wall.
nd
å
3 - Fasten the unit to the wall. Use the LONG SCREW through the other end of the SAFETY STRAP and into the 1/8" hole.
rd
Mark and drill
a 1/8" hole into
the wall stud.
1
st
Page 10
Electric drill with 1/8" bit
2
nd
3
rd
96
www.sauder.com/service 430621 / 211-4718