Blue Clean BC383HSS Instrucciones De Montaje página 8

ASSEMBLY INSTRUCTIONS
3
High Pressure Hose Assembly
Screw high pressure hose (D) clockwise onto bottom
front of power washer unit (A). Pull back collar and
insert o-ring post into water outlet far enough so
collar can thread onto outlet threads until hand tight.
If it takes fewer than six turns you have not properly
tightened the high pressure hose fitting. It is easier to
position the power washer in front of you to ensure that
the threads are started correctly. Failure to properly
tighten high pressure hose will result in the hose
slipping or popping off immediately upon turning unit
on. Do not worry about damage if this occurs–just
reinstall and take extra care when screwing on the high
pressure hose fitting.
Note: DO NOT use pliers or locking pliers to tighten.
5
I
3
D
2
Twist collar then pull back to release the the high
pressure hose (D) connection from the gun (I).
8
95505_IM_BC 383 HSS_ENG-FR-SP.indd 8
A
D
1
3
D
4
I
D
1
D
Pull back on collar at the other end of the high pressure
hose (D). Push firmly to connect hose to spray gun (I).
Twist collar to secure. Confirm hose is locked into spray
gun by slightly pulling on them. The hose is now
securely attached to spray gun.
6
1
Unlocked Locked
Locking Spray Gun (Before Lance Installation)
To lock trigger of spray gun (I), point gun away
from you and turn dial to lock ("3" and "9" position).
Squeeze or pull trigger to make sure it is locked.
ALWAYS leave in locked position when not in
use. This ensures the gun is in "safe" mode until it
is ready for use. Turn dial to unlock ("12" and "6"
position) to release spray gun trigger.
Note: The trigger lock prevents trigger from being
accidentally engaged.
2
3
I
2020/5/22 下午3:40