Greenlee Contact Information - Greenlee ES20LXR Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

• Always use a hot stick and follow rigorous hot

stick work practices when using this tool in

remote mode, to reduce the risk of injury.

• Never allow another high voltage conductor,

or grounded point to contact the instrument

during use. Always keep the tool housing clear of

all conductors to prevent shorting the circuit and

causing an arc flash that could result in severe

injury or death.

Failure to follow these warnings will result in severe

injury or death.

• Keep your fingers and hands away from the tool

head during the operating cycle. Remove battery

before touching the cutting head or attaching/

removing the hot stick adapter. Your fingers or

hands can be crushed, fractured, or amputated if

they become caught in the tool head or between

the tool head and other objects.

• Do not cut cable under tension. Cable can whip

and strike when cut and result in severe injury or

death

• Do not stand directly under overhead cables and

this tool when attached to a hot stick. The cable

or tool can fall and cause severe injuries or death.

• One person must control work process and

machine operation. Only the operator should

handle the tool and remote to reduce the risk of

injury.

• Do not modify tool. Modifying the tool in any

manner may result in personal injury and damage

to the tool. A tool with a cutting head that has been

welded, ground, drilled or modified in any manner

can break during use and throw parts that could

result in severe injury or death.

• Before use, inspect the tool and correct any

problems before using to reduce the risk of

injury and prevent product damage. If during

inspection, hydraulic oil has leaked from the tool or

damage to tool is observed or suspected, do not

use the tool. Large forces are generated during use

that can break or throw parts and cause injury.

• Confirm proper operation before and after each

use to reduce the risk of injury.

• Set up the tool and work area according to

these procedures to reduce the risk of injury.

Failure to follow these warnings could result in severe

injury or death.