Troubleshooting - Greenlee ES20LXR Manual De Instrucciones

Troubleshooting

1. Check that the battery is charged. If drained, charge and recheck the battery after several minutes to make sure
the battery is holding its charge.
2. Remove battery from tool.
3. Check the tool, see Pre-Operation Inspection.
4. Reinstall the battery and check the tool over again.
Consult the tables below for solutions to troubleshoot possible issues the tool may face. To aid troubleshooting, The
Tool Indicator LED Table (pg. 8) explains signals from the red LED on the tool that may occur.
Problem
Tool is does not activate when
pressing trigger.
Tool is does not activate when
pressing remote toggle.
Motor runs but tool will not
complete a cycle.
Red LED glows for 20
seconds.
Tool loses oil.
18
Possible Cause
Contaminants (dirt, rust etc.) in Cutting
Head.
Components Worn or Damaged
Motor is Not Working
Tool Set in Remote Profile
Low or Expired Battery
Broken Components
Tool in Handheld Profile
Wireless Receiver Damaged
Another Remote is Paired with Tool
Low Oil
Air in Hydraulic System
Cold Oil
Low Battery
Damaged Seal
© 2022 Greenlee Tools, Inc.
Solution
Remove battery and clean tool head thoroughly.
Send in for service.
Check battery charge and change battery if necessary.
Check for broken switch components and send in for service.
Change profile to Handheld.
Charge or Change battery.
Send in for service.
Change profile to Remote.
Send in for service.
Remove then replace battery to reset and follow steps to set up
Remote profile.
Send in for service.
Press trigger and hold retract button simultaneously. Run
for approximately 10 seconds, and then attempt to cut. If
unsuccessful, contact Greenlee customer service at 800-435-
0786 for warranty service or repair.
Press trigger and hold retract button simultaneously 10-20
seconds to warm oil. Press trigger and complete a cycle. Repeat
until tool completes a cycle successfully.
Charge or replace battery.
Send in for service.
ES20LXR
52093315 REV 0