Operating Instructions; Plug Into Power Source; Button Control - Ameda Pearl Instrucciones De Uso

7. OPERATING INSTRUCTIONS

7.1 Plug into Power Source (to charge battery or run on AC power)
Choosing and checking your electrical source
AC POWER ADAPTER
!
WARNING: Use ONLY the AC power adapter supplied with the Ameda Pearl Electric Breast Pump:
Model No. UES36LCP1-150200SPA.
WARNING: If the power adapter housing or wiring becomes loose, separated, or frayed, stop use of
!
the power adapter immediately and contact customer service at 1.866.992.6332. Stop using the device
immediately if you observe any smoke or burning from the pump unit or power adapter.
1. PUSH small end of the AC power adapter into the socket at the rear of the pump base as shown in
section 7.4
2. PLUG other end into the AC outlet as shown above

7.2 Button Control

D
A
A. POWER ON/OFF BUTTON
B. MODE SELECTION BUTTON
Switches between Stimulation Mode and
Expression Mode
C. - / + VACUUM LEVEL
Decreases or increases suction strength
during pumping
14 | ENGLISH
E
D. - / + SPEED
E. BACKLIGHT BUTTON
F. NIGHTLIGHT BUTTON
M
F
Decreases or increases suction speed
(cycles per minute)
C
B