Nacon DAIJA ARCADE STICK Guía Rápida página 17

Ocultar thumbs Ver también para DAIJA ARCADE STICK:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 36
I
To open up the top cover
Press the two unlock buttons on the cover (01) located on the side panels of the DAIJA
Arcade Stick.
I
Changing the joystick heads
You can use different joystick shapes which can be stored directly in your device's
storage compartment. Access the inside of the Arcade Stick and unscrew the head
installed by using the key provided or a flat-headed screwdriver. Next, screw the head
you want to use in via the same methods and close the compartment. Your Arcade Stick
is ready to use.
I
Removing the joystick mechanism and the action buttons
To change the joystick mechanism or the action buttons, access the Arcade Stick's
inside compartment by pressing the unlock buttons on the cover (01).
Once you've accessed the inside of your device, locate the cable corresponding to the
button you want to change, using the color code provided.
To unplug a button or the joystick, make sure to lift the sleeved part of the cable to avoid
damaging it.
Once the cable has been unplugged, simply remove the button by pressing the side
springs of the component. To remove the joystick mechanism, you'll need to use a
cross-headed screwdriver to unscrew the four holding screws.
You now have the possibility of installing your own components. Make sure to properly
plug the cables back in and replace the screws for the joystick mechanism.
TURN
I
Changing the front cover
You can replace the default front cover on your Daija Arcade Stick with the additional
design provided or with your own design by using the blank template provided. The
blank template can also be downloaded from www.nacongaming.com.
Remove the head of the joystick, then use the hexagonal screwdriver provided to remove
the nine screws on the protective panel on the surface of the Arcade Stick.
Please note: Make sure to print your template at the right scale, so that it perfectly
matches up the dimensions of the Arcade Stick. You'll need an A3 printer.
PRESS
EN /

Publicidad

Tabla de contenido
loading

Tabla de contenido