Protecting The Environment - DeWalt DWV905M Traducido De Las Instrucciones Originales

EnGLIsH
break through the material and into the hidden screw boss
below. Tighten.

CAUTION: Do not exceed 9 kg (30kg for model DWV9510)
in each 14 liter storage unit, maximum 2 storage units
per dust extractor. Do not exceed 18 kg in a 28 liter
storage unit, 1 storage unit per dust extractor. Exceeding
the recommended height and/or weight could result
in an unstable dust extractor would could cause injury
or damage. For model DWV9510, the recommended
height is 40 cm.

CAUTION: Do not carry the dust extractor at the handles
of the mounted storage units.
NOTICE: Do not remove dust extractor head from tank
with T-stack storage units attached. Doing so could result
in damage to the dust extractor filter.
NOTICE: The carry handle should be stored for possible
dismantling.
If the rack is to be removed again, this is done in reverse order.
The handle must be refitted and the two rear screws
be screwed back into the motor head enclosure, to close the
screw holes.
Securing the Power Cord to the Hose
(Fig. A)
The power cord 2 can be secured to the suction hose
using the D279058CL hose clip (available from your local
D WALT supplier).
e
Consult your dealer for further information on the
appropriate accessories.
Troubleshooting
Problem Solution
Motor does Check power cord, plugs and outlet.
not run
Ensure the on/off /tool control switch is in the
ON position ).
Suction Remove blockages in the suction nozzle,
capacity suction tube, suction hose or filters.
decreases
Replace the paper or fleece bag.
Check for proper installation of the filters.
Clean or replace the filters.
Empty canister, refer to Empty canister
under Operation.
30
Problem
Vacuum
stops
running
Dust comes
out while
vacuuming
32 must
Automatic
filter
cleaning is
not working
Power tool
7
does not
turn on.

Protecting the Environment

Separate collection. Products marked with this symbol
w
must not be disposed of with normal household waste.
Products contain materials that can be recovered or
recycled, reducing the demand for raw materials. Please
recycle electrical products according to local provisions. Further
information is available at www.2helpU.com.
Service
nOTE: If the dust extractor has to be sent for repair:
1. Contact the D
equipment to clarify possible hazards from extracted
hazardous materials.
2. Observe the following instructions for personal protection
during transport and in the service center:
a. Clean the device thoroughly inside and out.
b. Remove the filter/disposal bag.
c. If applicable, pack the device airtight in the plastic bag.
d. Attach a list of extracted hazardous materials to the
outside of the airtight package.
Solution
Thermal overload has been tripped:
1. Turn the vacuum off and disconnect
vacuum cleaner from power source.
2. Empty the canister, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an appropriate
outlet and turn on/off/tool control switch
to the ON position ) to test. If vacuum will
not restart contact your seller or check the
location of your nearest authorised D
repair agent in the D WALT catalogue or
e
contact your D WALT office at the address
e
indicated in this manual.
Check for proper installation of the filters.
Ensure filters are not damaged; replace
if necessary.
Ensure filter seals are in place and are secure.
Listen for the solenoid clicking to ensure the
filter cleaning mechanism is working.
Ensure the on/off/tool control switch is in the
ACTIVATION position
WALT service center before sending in
e
WALT
e
.