BOMANN CL 6044 QC CB Manual De Instrucciones página 80

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 47
Automatic temperature calculation
Self-cleaning for mildew
Interior Unit (a)
• Mount the interior unit on a solid wall which is not exposed to any
vibrations.
• None of the openings on the appliance must be blocked so that the
air can flow into the entire room.
• Do not mount the appliance close to heat sources, vapours or flam-
mable gases.
• Do not mount the appliance in a location where it will be exposed to
direct sunlight for long periods of time.
• Select a location in which condensate can easily drain and from
which the interior unit can be easily connected to the exterior unit.
• Check regularly to ensure proper functioning of the appliance and
always observe the guidelines regarding minimum distances and/or
keep these spaces clear. Select a location from which the filter can be
easily reached.
• Do not install the appliance in humid rooms such as bathrooms,
laundry rooms, etc.
• For optimum results, installation should be performed as high above
the floor as possible.
The minimum distances (in mm) are marked in the illustration.
CAUTION:
• The purchaser must ensure that persons / firms / companies which
install, maintain or repair these air conditioning units possess
sufficient qualifications and experience working with refrigerating
agents.
• Improper installation and operation without verification (e. g. certifi-
cate) from a specialist company shall cause the warranty to expire
in accordance with (EU) 517 / 2014 Chapter II Art. 3.
Installing the Wall Mount
CAUTION:
Before you install the wall mount, make sure you have found the
precise spot at which you are going to drill the hole for the pipes! See
the chapter entitled "Installation of the Interior Unit and Wall Bushing
to the Outside".
1. Loosen the wall mount at the locking clips.
80
CL6044CB_IM
Installation
Exterior Unit (b)
• Do not mount the exterior unit close to heat sources, vapour or flam-
mable gases.
• Do not set up the appliance in locations which are overly dusty.
• Install the appliance in an area in which nobody will be disturbed by
the operating noise and which is not frequented by many persons.
If necessary, make an arrangement with your next-door neighbours.
Consult the German Federal Emissions Protection Directive in this
regard, if necessary.
• Do not install the appliance in an area in which it will be exposed to
direct sunlight or severe weather conditions or use sun protection of a
kind which will not adversely affect air flow.
• Always observe the minimum distances depicted in the illustration be-
low and/or keep the space within this distance clear during installation
and operation.
• Install the exterior unit in a stable location.
• If the exterior unit is exposed to vibrations, use rubber bumpers on
the floor to counteract the influence of the vibrations.
2. Fold the wall mount upward.
Health feature (not available)
Not available
17.12.20

Publicidad

Tabla de contenido
loading

Tabla de contenido