Craftsman CX Serie Manual Del Operador página 36

Craftsman Snow Thrower Model 247.883980
777S32280
DANGER
NEVER PUT HAND IN CHUTE. CONTACT WITH
ROTATING PARTS CAN AMPUTATE FINGERS
AND HANDS.
SHUT OFF ENGINE AND WAIT UNTIL ALL
MOVING PARTS HAVE STOPPED BEFORE
UNCLOGGING.
USE CLEAN-OUT TOOL OR WOODEN STICK TO
UNCLOG DISCHARGE CHUTE.
AUGER CONTROL
GO
PARTS LIST
777D18046
777S32636
DANG ER
1. KEEP AWAY FROM ROTATING IMPELLER AND AUGER. CONTACT
WITH IMPELLER OR AUGER CAN AMPUTATE HANDS AND FEET.
2.
USE CLEAN-OUT TOOL TO UNCLOG DISCHARGE CHUTE.
3.
DISENGAGE CLUTCH LEVERS, STOP ENGINE, AND REMAIN BEHIND
HANDLES UNTIL ALL MOVING PARTS HAVE STOPPED BEFORE
UNCLOGGING OR SERVICING MACHINE.
4. TO AVOID THROWN OBJECTS INJURIES, NEVER DIRECT
DISCHARGE AT BYSTANDERS. USE EXTRA CAUTION WHEN
OPERATING ON GRAVEL SURFACES.
5.
READ OPERATOR'S MANUAL.
CLEAN-OUT TOO L
777I22340
LEFT TURN
TRIGGER CONTROL
777D18038
777D16340
777I23013
ON OFF
RIGHT TURN
DRIVE CONTROL
TRIGGER CONTROL
36
777I22341
CHUTE DIRECTIONAL CONTROL
DISCHARGE DISCHARGE
LEFT RIGHT
CHUTE TIL T
DOWN
CHUTE TIL T
UP
STARTING INSTRUCTIONS:
1.) INSERT KEY AND SNAP IN PLACE .
2.) MOVE THROTTLE CONTROL TO THE "F A ST"
POSITION.
3.) MOVE CHOKE CONTROL TO THE "CHOKE "
POSITION. PUSH PRIMER 3x.
4.) ROPE START: PULL SLOW LY UNTIL HARDE R
TO PULL, THEN PULL RAPIDLY TO START.
REPEA T PRIMING IF NEEDED.
ELECTRIC S TART: DO NOT USE IN RAI N.
CONNECT POWER CORD AND PUSH STARTE R
BUTTON. REPEAT PRIMING IF NEEDED.
5.) MOVE CHOKE CONTROL SLOWLY TO T HE
"RUN" POSITION.
6.) TO STOP ENGINE: MOVE THROTTLE TO TH E
"STOP" POSITION .
777D16353
OVERHEAD VALVE
420
cc
777I22363
G0