Operation; Tuning Procedure; Reference Pitch Settings - Korg Pitchblack X Pro Manual Del Usuario

Tuning procedure

1. Connect the instrument to be tuned to the INPUT1 jack or to the INPUT2 jack.
NOTE: If a plug is connected to the INPUT1 jack on the front panel, the INPUT2 jack on the rear
panel will be disabled and cannot be used.
2. Press the STANDBY/ON button to turn on the tuner.
The POWER ON LED will light up, and the calibration setting (0–9) will flash in the note display
for a few seconds.
NOTE: If there is no user input for up to 4 hours, the auto power-off function will automatically
put the tuner in the standby power mode. Holding down the MUTE button and pressing
the STANDBY/ON button while the tuner is turned on will disable the auto power-off
function.
3. Set the calibration, meter display and display color as necessary.
(→"Reference pitch settings" on page 5, "Meter display setting" on page 6, "Meter display
color settings" on page 7).
4. Play a single note on your instrument.
5. Tune while watching the meter display. The note display will indicate the note name that is closest
to the pitch you input.

Reference pitch settings

Set the reference pitch for tuning (the A note in the middle of the piano keyboard = A4).
The default setting is "0: 440 Hz".
1. Press the CALIB button.
The current setting is shown for several seconds on the display (lit → blinking).
2. While the current setting is shown, press the CALIB button to set the reference pitch.
Each time you press the CALIB button you will cycle through the following settings.
0: 440 Hz, 1: 441 Hz, 2: 442 Hz, 3: 443 Hz, 4: 444 Hz,
5: 445 Hz, 6: 436 Hz, 7: 437 Hz, 8: 438 Hz, 9: 439 Hz
3. When you've chosen the desired setting, wait for two seconds without pressing any buttons.
The new setting will blink in the note name display indicating that the reference pitch has been
set, and you can now use the tuner normally.

Operation

En-5