Use Instructions - WERKU WK403040 Instrucciones Originales

WK403040
8
4
1
1. Switch.
2. Air filter.
3. Hose.
4. Spray direction control.
5. Spray control.
6. Trigger.
7. Cup.
8. Spray control nut.

USE INSTRUCTIONS

Caution.
Before starting up the HVLP turbine paint
►
spray gun, we recommend that you carefully
read all of the instructions as indicated.
Please respect all regulations regarding the
►
prevention of accidents, health and safety di-
rectives for places of work, laws and applicable
restrictions.
The HVLP turbine paint spray gun must
►
only be used by persons who have been ins-
tructed in its use and only for the purposes for
which it has been designed.
Power supply.
Make sure the power supply is adapted to the
►
requirements shown on the information panel
of the HVLP turbine paint spray gun (fig.1).
Using the motor at low voltage will make it
►
operate slowly.
This will reduce performance and may cause
►
the motor to overheat.
All manuals and user guides at all-guides.com
Preparation.
►
the HVLP turbine paint spray gun.
5
►
6
painted must be prepared, and the paint diluted
7 until reaching the correct degree of viscosity.
►
3
free from dust, dirt and grease.
2 ►
mixed and free from lumps and other particles.
►
using the HVLP turbine paint spray gun, but
always check the manufacturer's instructions
on these products before using them.
Paint viscosity level.
►
for application using brushes or rollers, and are
not suitable for use with the HVLP turbine paint
spray gun if they are not previously diluted.
►
degree of viscosity of the paint to be used
(fig.2).
►
►
empty completely.
►
is determined by emptying times from 15 to 30
seconds.
►
for different types of material are as follows:
►
►
►
►
►
►
►
►
to empty out of the viscometer, it means it has
to be diluted further.
English
Do not use textured paints as they will block
To obtain a perfect finish, the surface being
Make sure that the surface being painted is
Make sure that the paint being used is correctly
A large number of liquids can be sprayed
Remember that most paints are supplied ready
The viscometer will help to decide the correct
First, fill the paint viscometer to the top.
Calculate the time the viscometer takes to
In general, the viscosity of a normal product
In general, emptying times for the viscometer
Plastic and latex paints:
Water-based paints:
Varnishes:
Oil-based paints:
Enamel paints:
Paints with aluminium:
Wood sealants:
If the paint takes an excessive amount of time
12
24-28 sec.
20-25 sec.
20-25 sec.
18-20 sec.
18-22 sec.
20-25 sec.
28-35 sec.