Cutting Height - Craftsman professional 247.381091 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Attaching Side Discharge Cover
Follow steps below to install the side discharge cover:
1.
Remove mulching baffle or grass bag adapter from unit by
disconnecting wing nuts.
2.
Attach side discharge cover to unit and secure with the three wing
nuts. See Figure 6.
ADJUSTMENTS

Cutting Height

There is a cutting height adjustment lever located above the rear left
wheel.
1.
Pull the height adjustment lever towards wheel.
2.
Move lever to desired position for a change in cutting height. See
Figure 7.
3.
Release lever towards deck.
Drive Control
The adjustment wheel is located in the drive control handle housing
and is used to tighten or loosen the drive belt. You will have to adjust
the drive control if any of the following happens:
1.
The mower does not propel itself with the drive control engaged.
2.
The mower's drive wheels hesitate with the drive control engaged.
If either of these conditions occur, rotate the adjustment wheel
clockwise to tighten and counter-clockwise to loosen cable to adjust
the drive control. See Figure 8.
NOTE: For some people the drive control may not be in a comfortable
position. You can adjust the handle position by tightening the adjust-
ment wheel.
ASSEMBLY
Tighten
Loosen
Figure 8
2
3
10
Figure 6
1
Figure 7

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido