Power Button; Reset Button - Geutebruck G-ST 500+ Manual De Instrucciones

G-ST 500+
8 System Status LED
There are four LED indicators on the front panel: PWR, HDD, WDT and IGN.
The descriptions of these four LEDs are listed in the following table.
Indicator
IGN
WDT
HDD
PWR

9 Power Button

The power button is a non-latched switch for ATX mode on/off operation. To turn on the
G-ST 500, press the power button and the PWR LED should light-up green. To turn off the
G-ST 500, issuing a shutdown command in OS is preferred, or you can simply press the
power button. To force shutdown when the system freezes, press and hold the power but-
ton for 5 seconds. Please note that there is a 5-second interval between on/off operations
(i.e. once turning off the system, there is a 5-second wait before you can power-on the sys-
tem).

10 Reset Button

The reset button is used to manually reset the system in case of system halt or malfunc-
tion. To avoid unexpected reset, the button is purposely placed behind the panel.
To reset, please use a pin-like object (eg. tip of a pen) to access the reset button.
Color
Green Ignition signal indicator, lid when IGN is high (12V/ 24V).
Yellow Watchdog timer indicator, flashing when WDT is active
Red Hard drive indicator, flashing when SATA drive is active
Green Power indictor, lid when system is on
Description
15
Back to the
table of contents