Install Mini-Pcie Module - Geutebruck G-ST 500+ Manual De Instrucciones

G-ST 500+

Install Mini-PCIe Module

Disassembling the System Enclosure
1. Turn the system upside-down.
2. Unscrew the six (6) screws indicated below on the front panel.
3. On the rear panel, remove the six (6) screws indicated.
4. Gently lift the bottom enclosure cover and disconnect any cables connected to the rear pa-
nel. Once disconnected, remove the rear
panel.
5. Remove the three (3) screws on the
MezIO card and gently lift the MezIO
TM
card (if you need to install mini-PCIe or
mSATA module on PCBA).
TM
25
Back to the
table of contents