Craftsman professional 247.88848 Manual Del Operador página 18

TO ENgAgE AUgER
1. To engage the auger and start throwing snow, squeeze the auger
control against the left handle. Release to stop the augers.
REPLACINg SHEAR PINS
The augers are secured to the spiral shaft with shear pins and bow-tie
cotter pins. If the auger should strike a foreign object or ice jam, the
snow thrower is designed so that the pins may shear. If the augers will
not turn, check to see if the pins have sheared. See Figure 17.
NOTE: Two extra shear pins are supplied in the manual bag.
CAUTION
NEVER replace the auger shear pins with anything other than OEM
Part No. 738-04155 replacement shear pins. Any damage to the
auger gearbox or other components as a result of failing to do so will
NOT be covered by your snow thrower's warranty.
WARNINg
Always turn off the snow thrower's engine and remove the key prior to
replacing shear pins.
OPERATION
Figure 17
18