9. In case of uneven road or other poor road conditions,
please slowdown in time and drive slowly and carefully or
get off and push it. The scooter is a special riding product,
please try to ride on a flat road without potholes.
11. Do not immerse the product in water more than 4 cm
deep to avoid damage to the battery of the scooter.
10. Do not ride on the ground with oil or ice on the surface.
12. Do not drive the scooter in snow orrain, , on muddy, icy
or wet, roads under any circumstancesand do not drive the
scooter over obstacles (sand, loose gravel or road block).
Doing so may result in loss of balance or grip. When riding
in rain, please keep your distance and avoid sudden
braking.
6
Warning LED flashes and the display values E1-E5 flash
Solution
Fault
Code
Please check whether the braking tail light is on. If it is not on this means that there is
Rx communication
E1
no power to the controller. Replace the controller or instrument. If it is on, please
failure
check whether the connecting line from the instrument to the controller is open.
Braking failure
E2
Please check if
If it is pressed, release the brake
the
brake
is
pressed
The connecting wire between the
braking and the instrument needs to
be checked on whether there is
short circuit or open circuit
Handle failure
E3
Please check if
If it is pressed, release the handle
the
handle
is
pressed
If not, please check the connecting
wire between the handle and the
instrument for short circuit or open
circuit
Controller failure
E5
If the controller is damaged, replace the controller
Tx communication
E7
Check the communication line
failure
Note: Regularly
check
the
tightness
of
,
system
steering
system
and
brake
shaft
Open circuit or short
circuit need to replace
the connecting wire
Replace
the
brake
handle
Replace
the
connecting wire for
open circuit or short
circuit
Replace the handle
,
bolted
parts
especially
the
fastenings
.
21
,
of
axle
folding