American Standard 6245 Serie Manual Del Propietário página 8

2
RETROFITTING WITH SELECTRONIC VAVLE
(Replaces Industry Standard Manual and Electronic Valves)
Note: In most Retrofits the wall escutcheon, stop valve, cover tube and vacuum breaker do not
have to be replaced. If these items do need replacement they must be purchased separately or
order the complete flush valve assembly from American Standard.
1. Remove STOP VALVE COVER (1) from STOP VALVE (2).
2. Turn water supply off.
3. Loosen SPUD COUPLING NUT (3). Unthread COUPLING NUT (4) and VACUUM BREAKER COUPLING
NUT (5).Remove FLUSH VALVE (6).
4. Clean all threaded connections before
installing the new flush valve.
5. Refer to Sections 4, 5 and 6 to complete
the retrofit installation.
C
3
REPLACE BATTERY
1. Unthread the two SET SCREWS (1). Fig. 11.
2. Use a flathead screwdriver to pry CAP (2) off the
flush valve cover to expose BATTERY HOLDER (5).
Fig. 11.
3. Remove old BATTERY from BATTERY HOLDER (5).
Install the new BATTERY (7) making sure the shape
of the BATTERY follows the shape of the BATTERY
HOLDER (5). Fig. 11a.
4. Insert BATTERY HOLDER (6) into flush valve
COVER (3). Fig. 11a.
5. Connect BATTERY HOLDER (5) to SENSOR (4) and
reverse the above steps to assemble flush valve.
Fig. 11a.
Note: When the battery is replaced, the sensor
light will flash 10 times
B H
6
2
CLEAN
CONNECTIONS
1
4
5
3
Fig. 11
Fig. 11a
STANDARD BATTERY
3
4
5
2
5
1
5
REMOVE OLD INSTALL
BATTERY NEW
BATTERY
- P 2
C R
- P 2
C R
7