Record Mode - auna Franklin Manual De Instrucciones

EN
36
Notes on the radio mode
• Set the FM selector switch to the HI position. Stations are then received
in mono. This is especially recommended for weak stereo reception.
• Set the FM selector switch to the NOR position to receive stations in
stereo. The ST indicator appears on the display and shows that the
station is being received in stereo.
• The radio receiver has a built-in wire antenna that hangs from the back
of the housing. This cable should be unwound completely for optimal
reception.

RECORD MODE

• Remove the needle guard.
• Make sure that the tone arm is detached from the tone arm rest before
operation and then reattached.
Pickup
Needle guard
1. Set the function switch to PHONO (record).
2. Set the speed control to the correct speed depending on the record to
be played.
3. Place the record on the turntable (use the spindle adapter if necessary).
4. Lift the tone arm out of the holder and slowly move it to the record side.
The turntable starts to spin.