Maintenance; Cleaning And Care; Trouble Shooting - Johnson JSC8B Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATIONS

Cleaning And Care

Clean the lint filter
Leave the dryer to cool down.
1.Open the machine door.
2.Take out the lint filter, pull
upward to take it out.
3.Clean the lint filter; wipe off
the scrap threads accumulated
on the lint filter, with your hand or
rinse with water and dry thoroughly.
4.Reinstall the lint filter.
Note!
The lint filter accumulated on the filter will block the air circulation, which will
cause the extension of drying time and energy use; therefore, the scrap thread
filter shall be cleaned after each use.
Do disconnect the power cord before cleaning!
Do not operate the dryer without the lint filter!
Clean the lint filter after each use to prevent lint accumulation inside the dryer.
Wash air condenser
Leave the dryer to cool down.
Residual water may escape, place an absorbent
cloth under the maintenance cover.
1. Unlock the maintenance cover.
2. Completely open maintenace cover.
3. Screw both locking levers towards each other.
4. Pool out the air condenser.
5. Clean the air condenser completely, drain thoroughly.
6. Clean the seals.
7. Re-insert the air condenser, handle at the button!
8. Unscrew both locking levers.
9. Cloth the maintenance cover until it locks into position.
Please clean the air condenser approx, once every 3
months if frequently used.
Do not damage the air condenser!
Warning!
• Clean with water only; do not use hard/sharp-edged objects!
Do not operate the dryer without the air condenser!
• During drying, water may collect between the window and the
seal, but this does not affect the function of your dryer!
V.1
17

MAINTENANCE

Empty the water container
1.Hold and pull out the water container with two hands.
2.Tilt the water container, pour out the condensate water.
3.Insert the water container.
Warning!
• Empty the water container after each use, the programme will be paused and
the "
" icon will light if the water container is full during the drying process.
After the container is emptyed, the dryer can be restarted by pressing
【Start/Pause】 button.
• Do not drink the condensate water.
• Do not use the dryer without the water container.

Trouble Shooting

Alarm Problem
Alarm Reason
"
E30
"
Heating problem
Humidity sensor error
"
E32
"
Temprature sensor error
"
E33
"
Release
P lease contact your local service
center if the problem persists.
V.1
18

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido