Solving Problems; Correcting Problems Yourself - Dirt Devil AC150 Manual De Instrucciones

5 Solving problems

5.1 Correcting problems yourself

Before contacting the service hotline ( page 102, „International Service"), please check if you can solve the prob-
lem yourself using the following table.
WARNING:
Never use a faulty appliance or operate an appliance with a faulty power cord.
Before you try to localise the problem, switch off the appliance and pull the plug from the mains socket.
Problem
The appliance will The power cord is not
not start plugged in.
The front panel or the
HEPA/carbon filter is not
inserted properly.
The appliance The timer function had
switches itself off been activated.
The "Odor Filter" The carbon filter needs to
LED above the be replaced.
button lights
up
The "HEPA" LED The HEPA filter needs to
above the be replaced.
button lights up
The appliance is The highest power level
unusually loud ("H") has been set.
when running
One of the filters is soiled
and has to be replaced.
The air inlet or outlet is not
free from obstructions.
NOTE:
If you cannot solve the problem using this table, contact the Dirt Devil customer service department ( page
102, „International Service").
30
Possible cause
Insert the plug into the mains socket.
Check whether the front panel and the HEPA/carbon filter are
inserted correctly, see chapter 4.2, „Replacing the carbon fil-
ter" or chapter 4.3, „Replacing the HEPA filter" respectively.
See chapter 3.4, „Setting the timer" for information on se-
lecting and deselecting the timer function.
Replace the carbon filter as described in chapter 4.2, „Re-
placing the carbon filter".
Replace the HEPA filter as described in
ing the HEPA filter".
Select a power level which you find more pleasant, chapter
3.3, „Selecting the power".
Replace the filters as described in chapter 4.2, „Replacing the
carbon filter" and chapter 4.3, „Replacing the HEPA filter".
Make sure that there is sufficient free space around the air inlet
and outlet.
Solution
chapter 4.3, „Replac-