Ohyama WOOZOO AP45-M Manual De Usuario página 13

K
■ Set the sensor sensitivity
Set the sensor sensitivity. Use this function when the
light of dust monitor screen remains red or red light
sometimes comes on.
Be sure to perform this after turning off the power.
Hold the turbo button
• To emit bip sounds and set to the sensitivity setting
mode.
Press the operation mode button to
change your preferred sensitivity
• Every time the button is pressed, the product emits
bip sounds to change the sensibility as below.
• Perform the setting within 10 seconds. After 10
seconds, the product will emit beep sounds and the
adjustment will end automatically.
• Factory default setting is set to Sensitivity 1.
Sensitivity
Low
High
Press operation OFF/ON button
• The product emits beep sounds to confirm the set
sensitivity.
Hold the button for 3
seconds or longer.
lamp
Sensitivity 4
Sensitivity 3
Sensitivity 2
Sensitivity 1
■ Adjust the air flow direction
The flap of air outlet will adjust the air flow direction.
For your safety, the flap is designed to be removed
easily. If it's removed, install it in the following manner
(pay attention to the direction).
.
Put the left side shaft (thicker one) to the hole
.
Bending
.
Put the right side shaft to the hole
13
AP45-M
2 2
1 1
3 3