Safety; Intended Use Of The Machine; Technical Restrictions; Prohibited Use / Hazardous Misapplications - Zipper ZI-EWB500 Instrucciones De Servicio

11

SAFETY

This section contains information and important notes on safe start-up and handling of the machine.
For your own safety, read these operating instructions carefully before putting the machine
into operation. This will enable you to handle the machine safely and prevent misunder-
standings as well as personal injury and damage to property. In addition, observe the sym-
bols and pictograms used on the machine as well as the safety and hazard information!
11.1

Intended use of the machine

The machinery is intended exclusively for the following operations: Transportation of gods within the max-
imum permissiable load capacity.
ZIPPER-MASCHINEN assumes no responsibility or warranty for any other use or use beyond this and for
any resulting damage to property or injury.
11.1.1

Technical Restrictions

The machine is intended for use under the following ambient conditions:
Relative humidity:
Temperature (for operation)
The machine, especially the battery; may not be exposed to a temperature of about 80 °C. Do not store in
the blazing sun or a long time in the trunk of a car.
11.1.2

Prohibited Use / Hazardous misapplications

Operating the machine without adequate physical and mental aptitude
-
Operating the machine without knowledge of the operating instructions
-
- Changes in the design of the machine
- Operating the machine in wet and rainy conditions
Operating the machine outside the technical limits specified in this manual
-
Remove the safety markings attached to the machine
-
- Modify, circumvent or disable the safety devices of the machine
The improper use or disregard of the versions and instructions described in this manual will result in the
voiding of all warranty and compensation claims against Zipper Maschinen GmbH.
11.2

User Requirements

The machine is designed for operation by one person. The physical and mental aptitude as well as
knowledge and understanding of the operating instructions are prerequisites for operating the machine.
Persons who, because of their physical, sensory or mental abilities or their inexperience or ignorance, are
unable to operate the machinery safely must not use it without supervision or instruction from a responsi-
ble person.
Basic knowledge of metalworking especially the correlation of material, tool, feed and speeds.
Please note that local laws and regulations may determine the minimum age of the operator and restrict the
use of this machine!
Put on your personal protective equipment before working on the machine.
Work on electrical components or equipment may only be carried out by a qualified electrician or under the
instruction and supervision of a qualified electrician.
11.3

General safety instructions

To avoid malfunctions, damage and health hazards when working with the machine, the following points
must be observed in addition to the general rules for safe working:
Before start-up, check the machine for completeness and function. Only use the machine if
•
the guards and other non-parting guards required for machining have been fitted, are in
good operating condition and have been properly maintained.
• Ensure sufficient lighting conditions at the workplace to ensure safe handling of the ma-
chine.
• Remove tool keys and other adjustment tools before switching on the machine.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
ZI-EWB500-AKKU
max. 65 %
+5° C bis +40° C
SAFETY
21