Troubleshooting - Truper DES-330 Instructivo

Desmalezadora a gasolina
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Grass trimmer storage
When the tool is stored one month or longer consider the following:
• Drain the fuel tank contents into a gasoline designated container. All the remaining fuel shall be re-used in other
equipment using 2-stroke motors with 40:1 ratio.
• Run the motor until burning the rest of the fuel and it off. This way all residual fuel will be eliminated and will prevent
gum deposit build up that damages the fuel system.
• Clean the tool thoroughly.
•Store the unit in a ventilated area, away from corrosive agents such as garden chemical products or de-icing salt. Keep it
away from the reach of children.
• Obey all the government regulations concerning fuel handling and management.
Problem
Cause
Motor does not start.
• There is no spark.
• No fuel.
• The motor is flooded.
• The starter handle is
difficult to pull out when
new.
The motor starts but
• The motor need a
does not accelerate.
couple of minutes to
warm up.
The motor starts bur
• Carburetor need
runs only at high
adjustment.
speed with half- a
choke.
• Check the oil / fuel
mix.
The motor does not
• The air filter is dirty.
get to full speed and
has too much smoke
• The spark arrest
emissions.
screen is dirty.
The motor starts, runs
• The idle speed screw
and accelerates but
in the carburetor needs
there is no idle speed.
adjustment.
12
ENGLISH
Maintenance

Troubleshooting

Solution
• Check the spark. Remove the motor cover. Remove the spark plug from
the cylinder. Connect the spark plug cable and set it onto the motor
cylinder with the metallic side touching the cylinder. Pull the starter handle
and watch the spark in the spark plug electrode. If there is no spark, repeat
the test with a new spark plug.
• Press the primer bulb until the fuel is visible in the choke. If the fuel is not
visible, it means that the fuel primary supply system is blocked. Contact a
Authorized Service Center. If the primer bulb is filled
with fuel, it means the motor is flooded.
• With the switches in the OFF position, remove the spark plug. Set the
choke lever downwards and pull the choke lever 15 to 20 times to
eliminate the excessive fuel from the motor. Clean the spark plug and set
it back. Follow the normal start up procedure (see page 9). If the motor is
not starting, move the choke lever downwards and repeat the starting
procedure. If the motor is still not starting, repeat the procedure with a
new spark plug.
• Take the tool to a
• Allow the motor to warm up completely. If there is no throttle after three
minutes contact a
• Take the tool to a
• Use new fuel and the right oil mix for 2-cycle motors.
• Clean the air filter. See page 11
• Take the tool to a
• Turn the idle screw clockwise to increase speed.
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.

Hide quick links:

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

11029

Tabla de contenido