Troubleshooting - Truper COS-26X Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Cause
The motor does not
• There is no spark.
start.
• There is no fuel.
• The motor is flooded.
• It´s more difficult to pull
the starter than when the
machine was new.
The motor starts but
• The motor requires a
has no throttle.
couple of minutes
warming up.
The motor starts but it
• The carburetor needs
only runs at high
adjusting.
speed with half a
choke.
• Double-check the
The motor does not
oil/fuel mix.
reach its full speed
• The air filter is dirty.
and has too much
• The spark deflector
smoke emission.
screen is dirty.
The motor starts,
• The idle screw in the
works and accelerates
carburetor needs
but is not work idle.
adjusting.
10
ENGLISH

Troubleshooting

Solution
• Double-check the spark. Remove the motor cover. Remove the spark
plug from the cylinder.
Connect the spark plug cable and place it onto the motor cylinder with the
metallic part touching the motor. Pull the starter and watch the spark in the
spark plug electrode. If there is no spark, try again using a new spark plug.
• Press the primer bulb until the fuel is visible in the bulb. If fuel is not
visible, it means the fuel supply primary system is blocked. Contact a
Authorized Service Center.
If the primer bulb gets filled with fuel, it means the motor is flooded.
• With the switch off, remove the spark plug. Set the choke lever into the
"
" position and pull the choke handle 15 to 20 times to eliminate
excessive fuel in the motor. Clean the spark plug and reinstall. Follow the
normal start process (see page 7). If the motor is not starting, set the
choke lever into the "
" position and repeat the starting process. If
after these procedures, the motor is still not starting, repeat the procedure
using a new spark plug.
• Take the tool to a
• Allow the motor to warm up completely. If after 3 minutes is does not
accelerate go to your
• Take the tool to a
• Use fresh fuel and the right oil mix for two-cycle motor.
• Clean the air filter. See page 9.
• Take the tool to a
• Turn the idle screw clockwise to increase speed. See page 9.
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

12251

Tabla de contenido