Operation - TECE TECEprofil WC-Modul Instrucciones De Uso

Initial operation
In order to put the hygiene flush into operation, the plug for the hygiene flush
unit is connected to the transformer plug. When powered, a start sequence will
EN
run. Open the valves one after another for five seconds and allow water to flow
through. This allows you to see whether the shut-off valves have been moved to
the operation position, that the valves are functions and that a current is present.
Practical tip:
If the hygiene flush is put into operation accidentally without flushing the pipe-
lines first, the hygiene flush unit can also be disassembled at a later point and
the filters can be cleaned.

5. Operation

General
The TECE hygiene flush can either be operated via
the TECEsmartflow app (part of the TECEsmartcontrol
app) or the connection to the building control techno-
logy (BCT). There are two options for operation when
connecting a BCT:
• Setting the flush programme via the Smartflow app.
The BCT only monitors the programmed flush
programmes via the output interface of the hygiene
flush.
• The flush programmes and scenarios are determi-
ned by the BCT.
The BCT uses the input and output interface of the hygiene flush and con-
trols the programming of the hygiene flush.
Connection setup - App
To use the Smartflow app you will need
• a TECE hygiene flush with power supply,
• a Bluetooth enabled device (mobile/tablet) and
• the TECEsmartflow app;
here is the code for download in the App Store & Play Store:
After starting the app, a pop-up will request Bluetooth activation, then the app
home view will appear. Press „Pull-down to refresh" or press the „Search for
devices" button to allow the app to search for nearby hygiene flushes. Selecting
the hygiene flushes shown will establish a connection.
24