Oven Installation - Furrion FMSN09A-BL Manual De Usuario

Bottom Duct Installation (sold
together with FMSN09A-BL-
TK or FMSN09-SS-TK trimkit)
1. Mark out the cabinet center line as
shown in the figure below.
Cabinet center line
2. Locate the bottom duct into the
cabinet opening. Ensure the duct
bottom is center aligned to the
cabinet center line. Fix the bottom
duct with four M4 x 3/8" self-tapping
screws.
Bottom duct and cabinet
are aligned as shown.
Trim Kit Installation
(FMSN09A-BL-TK/FMSN09A-
SS-TK, not included)
1. Remove the trim kit from the
packaging. Check to make sure it is
not damaged.
2. Fit the trim kit over the oven front
panel and fix with four M4 x 5/8" self-
tapping screws on side.
Upper Duct Installation (sold
together with FMSN09A-BL-
TK or FMSN09-SS-TK trimkit)
Install the upper duct on the top of the
oven and fix it with four M4 x 5/8" self-
tapping screws.

Oven Installation

Slide the microwave oven into the
cabinet opening and fix it to the cabinet
with four M4 x 3/8" self-tapping screws.
- 10 - CCD-0005771 Rev: 09-16-22