Possible Errors - DELTA-SPORT QC-8608 Instrucciones De Manejo

Possible errors

Potential errors are listed below, along with their causes and how to rectify them.
Error Possible cause
Remote control Remote control (2) is
(2) does not switched off.
respond.
Batteries (5) incorrectly
inserted.
Batteries (5) are flat.
The quadcopter The batteries (5) in the
(1) does not remote control (2) were
respond. incorrectly inserted or
are flat.
The rechargeable battery
(3) in the quadcopter (1)
is flat.
The indicator lights (1g)
do not flash or light up.
The quadcopter (1) is out
of range.
The quadcopter Too strong a wind or
(1) cannot be draught.
controlled.
The quadcopter (1) needs
to be calibrated.
The quadcopter Not enough throttle.
(1) will not fly
The rechargeable battery
upwards.
(3) is flat.
The rotor Collision, crash.
guards (1c) are
not securely
fixed.
The quadcopter Contact has not been
(1) indicator established between the
lights (1g) flash quadcopter (1) and the
alternately. remote control (2).
The rechargeable battery
(3) is almost flat.
42 GB/IE
Remedy
Turn on remote control (2).
Insert the batteries (5) correctly.
Replace the batteries (5).
Check the batteries (5) and replace if necessary.
Charge the rechargeable battery (3).
Insert the rechargeable battery (3) into the
quadcopter until it locks firmly in place.
Make sure that the distance between the remote
control (2) and the quadcopter (1) is not more than
30m.
The quadcopter (1) is only suitable for calm conditions
with no wind or up to force 3 winds.
Place the powered-on quadcopter (1) on a horizontal,
level surface. Simultaneously slide the throttle (2h)
and the control lever (2l) on the powered-on remote
control (2) towards yourself and at an angle outwards.
The indicator lights (1g) on the quadcopter (1) will
flash for approx. 3 seconds. Once the indicator
lights (1g) are steadily illuminated, the calibration is
complete and the quadcopter (1) is ready to fly.
NOTE: repeat the calibration if the quadcopter
(1) still flies erratically in one direction.
Slide the throttle (2h) forward completely.
Charge the rechargeable battery (3).
If the rotor guards (1c) become loose, firmly reattach
them and check the function and correct placement of
the rotor guards (1c).
Slide the throttle (2h) on the remote control (2) all the
way forward, and then all the way back.
This process establishes contact between the
quadcopter (1) and the remote control (2).
Switch off the quadcopter (1) and remove the
rechargeable battery (3), so it can be charged.