LEGRAND KEOR TOWER SPE Manual De Instalacion Y Uso página 44

•
In case of attempting to perform a battery test while the UPS is
running in battery mode, the 7-segment display will show 'noP'
for 7 seconds, then return to the previously viewed data.
ENTER
The button has three functions:
1. Buzzer ON/OFF
When the buzzer is active, press the button for 0.1 seconds to silence the
current alarm. In case of a new alarm (same or different alarm; no matter), the
buzzer will reactivate automatically. When the buzzer is muted, press the
button for 0.1 seconds to turn it on again.
Not available in setup mode.
2. Enter the Setup Mode
Press and hold the button for 3 seconds until you hear one beep and the "SET"
icon will be turned on.
3. Confirm
In Setup Mode, press the button for 0.1 seconds to:
•
Enable the editing of the current setting. As confirmation, the value
on the digits will start to flash.
•
Save the changes of the current setting. As confirmation, you will
hear one beep and the value on the digits stop to flash.
KEOR TOWER SPE
Installation and User Manual
45