Corsair VOID RGB ELITE WIRELESS Manual De Instrucciones página 9

This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Any changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate
this equipment.
This product complies with the FCC portable
RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as
described in this manual. The further RF exposure
reduction can be achieved if the product can be
kept as far as possible from the user body or set
the device to lower output power if such function
is available.
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device.
This product complies with the Canada portable
RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as
described in this manual. The further RF exposure
reduction can be achieved if the product can be
kept as far as possible from the user body or set
the device to lower output power if such function
is available.
Le présent appareil est conforme aux CNR d' ISED
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions
suivantes:
(1) le dispositif ne doit pas produire de brouillage
préjudiciable, et
(2) ce dispositif doit accepter tout brouillage reçu, y
compris un brouillage susceptible de provoquer un
fonctionnement indésirable.
Ce produit est conforme aux restrictions
d'exposition aux RF portables du Canada définies
pour un environnement non contrôlé et sûr pour le
fonctionnement envisagé, tel que décrit dans ce
manuel. Les niveaux d'exposition peuvent continuer
à baisser si le produit peut être éloigné le plus
possible de l'utilisateur, ou si l'appareil est défini sur
une puissance de sortie inférieure, sous réserve que
cette fonction soit disponible.
This Class B digital apparatus meets all
requirements of the Canadian Interference-Causing
Equipment Regulations.
CAN ICES-3(B)/NMB-3(B)
Este equipment não tem direito à proteção contra interferência prejudicial e não pode causar interferência
em sistemas devidamente autorizados
Cet appareil numérique de la class B respecte
toutes les exigences du Règlement sur le materiel
brouilleur du Canada.
CAN ICES-3(B)/NMB-3(B)