Fagor AL-350 Manual De Instrucciones página 10

interior.qxd 1/4/03
4. INSTRUCTIONS FOR USE
• Place the tin on a flat surface.
• Plug the tin opener into the mains.
• Place the piecing lever in an upright
position and lift the hinged magnet (fig.
A).
• Place the tin opener on the tin so that
the outer edge of the tin is positioned
over the toothed wheel (fig. B).
• Lower the piecing lever without pressing
the ON switch, so that the blade rests on
the lid of the tin (fig. C).
• Lower the magnet onto the tin lid.
• Press down hard on the piecing lever to
begin the cutting process. You do not
need to turn the tin – the appliance will
do this automatically.
• You do not need to keep pressing down
on the lever once the cutting process is
underway.
• When the cutting process is completed,
the tin opener will stop automatically as
long as you are not pressing down on
the piercing lever. The lid will remain
attached to the magnet.
• Lift the piercing lever to release the tin
and then remove the lid from the
magnet, being careful not to cut yourself
on the sharp edges. Before lifting the
lever, make sure you are holding the tin
firmly or that it is resting on a stable
surface.
5. CLEANING
Unplug the appliance from the mains.
To remove the piercing lever, lift it up as
far as it will go and pull outwards (fig. D).
Clean the lever with warm soapy water
and dry well.
Keep the blade clean at all times.
Clean the tin opener with a damp cloth
and dry well. Do not submerge in water.
To replace the lever, simply repeat the
process in reverse, making sure that the
groove coincides with the corresponding
tongue (fig. D). There is only one correct
position. When the lever is correctly
inserted, simply return it to its usual
position.
12:04 Página 8
This appliance is guaranteed for one year
from time of purchase, against any
manufacturing defect.
The guarantee will be annulled if the
damage has been caused by incorrect use
or handling by anyone other than Fagor
Technical Services personnel.
Whenever guarantee services are
requested, the Guarantee Card must be
presented with the date of purchase and
the seller's stamp.
The guarantee holder always has the
statutory rights recognized by law.
The manufacturer reserves the right to
modify the models described in this User's
Manual.
10
6. GUARANTEE