Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
INSTALLATION - CONNECTION
Connect each component to the symbol added next to each relay (cables not included).
Please follow the order of connection in accordance with the polarities.
In case of non-compliance, your solar charge controller as well as your battery may be damaged.
Connect your battery to the solar charge controller (+ and -)
The battery light is on
Select your battery technology:
- Press the button to activate the "battery choice" mode
The battery light starts blinking.
- Press the button for 5 seconds to enter in the menu.
The number starts blinking.
- Press the buttom to choose the figure corresponding to your battery technology
Figure
1
2
3
- To confirm your selection, wait for 5 to 7 secondsfor the light to become fixed again. Unisolar
memorizes your set up.
Define your « load destribution». This mode permits to divide in % the
charge of the solar panel on each battery:
- Press the button to activite the mode. The light starts blinking.
- Press the button for 5 seconds to enter the menu. The number starts blinking.
- Press the button to choose the figure corresponding to the desired « load destribution».
26
Technology
AGM : Lead acid batteries maintenance-free, AGM...
GEL : Gel cell batteries
LIQUID : Liquid lead/acid batteries (specified open, plug...)
Figure
0
1
2
3
4
5
6
7
8
9
90%(factory setting)
Battery 1
Battery 2
0%
10%
20%
30%
40%
50%
60%
70%
80%
www.uniteck.fr
100%
90%
80%
70%
60%
50%
40%
30%
20%
10%
Publicidad
Tabla de contenido
