Binks EMG Serie Manual De Mantenimiento página 13

Jerky or fluttering spray
Paint bubbles in cup
Fluid leaking or dripping
from cup lid
Starved spray pattern
Excessive overspray
Dry spray
SB-E-2-852-R1.0
All manuals and user guides at all-guides.com
Loose or damaged
fluid tip/seat.
Loose or broken cup
fluid nipple.
Material level too
low.
Container tipped too
far.
Obstruction in fluid
passage.
Loose fluid needle
packing nut.
Damaged fluid
needle packing.
Fluid tip not tight.
Cup lid loose.
Dirty cup or lid.
Cracked cup or lid.
Inadequate material
flow.
Blocked vent in Cup
lid.
Low atomisation air
pressure.
Air pressure too high.
Gun too far from
work surface.
Air pressure too high.
Gun too far from
work surface.
Gun motion too fast.
Fluid flow too low.
Page 13 of 16
Tighten or replace.
Tighten or replace cup.
Refill.
Hold more upright.
Back flush with solvent.
Tighten.
Replace.
Tighten to 18–20 Nm (160–180
lbs.in).
Push in or replace.
Clean.
Replace cup and lid.
Wind fluid adjusting knob out or
change to larger fluid tip size.
Clean lid and unblock vent.
Increase air pressure and rebalance
gun.
Reduce air pressure.
Adjust to correct distance.
Reduce air pressure.
Adjust to correct distance.
Slow down.
Wind out needle adjusting screw or
use larger fluid tip size.
EN