Husky MP180 Guía De Uso Y Cuidado página 16

Operation Instruction – MIG Mode (continued)
5
Setting Up for MIG/Flux Core Welding
□
Double check your input voltage:
For 120V: Switch voltage switch (Q) to 120V, use a 240V to 120V
adapter while connecting to the 120V power source.
For 240V: Switch voltage switch (Q) to 240V, connect to 240V
power source.
□
Check your welding wire type:
For flux core wire: Connect the ground clamp cable to positive (+)
DINSE socket (N) and electrode polarity jumper (H) to negative (-)
DINSE socket (M).
For solid core wire: Connect the ground clamp cable to the
negative (-) DINSE socket (M) and electrode polarity jumper (H) to
positive (+) DINSE socket (N).
□
For flux core wire, no shielding gas is needed.
□
For solid core wire, follow instruction "Connecting the Gas
Cylinder (MIG)" and connect one side of gas hose to gas regulator
on the gas cylinder and the other side to the gas input (R) at the
back of welder.
□
Ensure your workpiece is clean and dry; make sure the ground
clamp has a good connection to the workpiece.
□
Connect MIG/flux core MIG gun to the gun cable socket (G) and
control socket (I).
□
Open the side panel. Load the wire spool and feed the wire into
the wire feeder. For detailed instructions please see "Installing the
Wire Spool" and "Setting up the Welding Wire."
□
Make sure your MIG gun/ spool gun switch (U) is set to MIG gun.
□
Ensure you are not pointing the MIG/flux core MIG gun to yourself
and any other bystanders. Switch the ON/OFF power switch (O) to
ON at the back of the welder. Push the welding mode switch
button (K) until MIG LED turns on.
□
Follow instructions "Setting Up the Welding Wire," and feed the
welding wire into the wire feeder and flux core gun. Press the
MIG/flux core MIG gun trigger to load welding wire through the
flux core gun.
□
Adjust left knob (E) to set your wire feed speed.
□
Adjust middle knob (D) to set your welding voltage.
□
Hold the MIG/flux core MIG gun to the workpiece and press the
gun trigger. The weld arc can be initiated by touching the weld
wire to the workpiece.
16