Adjusting The Tilt Stand; Connecting The Ir-Usb Cable - Keysight Technologies U1231A Guia Del Usuario

Adjusting the tilt stand

To adjust the multimeter to a 60° standing position, pull the tilt stand outward as
shown in
Figure 1-3

Connecting the IR-USB cable

You can use the IR communication link (IR communication port, located at the
rear panel) and the Keysight GUI Data Logger software to control your multimeter
remotely, perform data logging operations, and transfer the contents of your
multimeter's memory to a PC.
Ensure that the Keysight logo on the U1173A IR-USB cable (purchased
separately) connected to the multimeter is facing up. Firmly push the IR head into
the multimeter's IR communication port until it snaps into place (see
Keysight U1231A, U1232A, and U1233A User's Guide
Figure 1-3.
Pull until 60° standing position
Tilt-stand adjustment and IR-USB cable connection
To PC (host)
IR-USB cable
Tilt stand
Introduction 1
Figure 1-3).
31