Capturing Maximum And Minimum Values (Maxmin) - Keysight Technologies U1231A Guia Del Usuario

3 Multimeter Features

Capturing Maximum and Minimum Values (MaxMin)

The MaxMin operation stores the maximum, minimum, and average input values
during a series of measurements.
When the input goes below the recorded minimum value or above the recorded
maximum value, the multimeter beeps and records the new value. The multimeter
also calculates an average of all readings taken since the MaxMin mode was
activated.
From the multimeter's display, you can view the following statistical data for any
set of readings:
– Max: highest reading since the MaxMin function was enabled
– Min: lowest reading since the MaxMin function was enabled
– Avg: average or mean of all readings since the MaxMin function was enabled
– MaxMinAvg: present reading (actual input signal value)
This function is applicable to all measurements except for VZ
NOTE
1 Press
2 Press
3 Press
4 Press
Figure 3-4
90
to enable the MaxMin operation.
Max
Min
again to cycle through the Max, Min, Avg, or present (MaxMinAvg)
Max
Min
input values.
to restart the recording session.
for more than 1 second to disable the MaxMin function.
Max
Min
MaxMin display
Keysight U1231A, U1232A, and U1233A User's Guide
.
LOW