Introduction - BONAIRE 2800 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Bonaire Window Cooler

Introduction

GENERAL INFORMATION
Thank you for purchasing a quality Bonaire Evaporative Cooler. We care about your safety and would ask
you to spend a few minutes reading these simple instructions before installing or operating this product.
Safety!
Read carefully all of these instructions prior to installing and
operating the unit.
Read and Save these Instructions. Do not throw these Instructions away.
Complete the unit assembly before attempting to install, refer to page 7.
Installation of this cooler in any manner not prescribed by these instructions could cause a safety
issue and WILL void any warranty.
Use only with a 110 V 60 Hz single phase grounded outlet.
Do not operate cooler with Rear and Side Filter Panels removed.
Do not operate cooler with a damaged cord, plug or other component.
Do not run the power cord under carpet or other floor covering.
Do not use the power cord with an adaptor plug that converts the 3 pin plug into a 2 prong connector.
Do not use the cooler with an improperly grounded outlet.
Do not alter or modify this cooler.
Do not allow children to install, operate or service this cooler.
WARNING
: To reduce the risk of fire or electric shock, do not use this product with any solid state
speed control device.
Use only qualified electricians for replacement or servicing of switches, or electrical motors and
components in this cooler.
Unplug the cooler and press the Motor switch to the OFF position when installing, servicing or cleaning.
This Window Mounted Cooler is suitable for installation in windows (either Sash hung or sliding)with a
minimum opening width of 560mm
for correct mounting are adhered to for the SAFE operation of this Cooler.
and Height of 381mm
please ensure that the directions
Page
2

Publicidad

Tabla de contenido
loading

Tabla de contenido