BM2 BIEMMEDUE MS 13 Manual Del Usuario página 7

EN
IMPORTANT
Before using the equipment, carefully read all of the instructions and follow them
scrupulously. The manufacturer cannot be held responsible for damage to persons and/or
property caused by improper use of the equipment.
This instruction manual is an integral part of the equipment and must therefore be stored
carefully and passed on with the unit in the event of a change of ownership.
Safety check before operation
Plug: The standard single-brush machine comes fitted with a standard EU schuko plug. Before
connecting the appliance to the power socket check that the technical data match those of the
current network.
Cable: Before operating the machine check that the power supply cable is in good condition and
has no cuts or abrasions revealing the internal wires. In case the plug or cable are not satisfactory,
do not use the machine and contact your maintenance department immediately.
Machine failure: If for any reason the machine fails to start once it has been correctly plugged into
a power socket and turned on, do not attempt any form of repair. Contact your maintenance
department immediately.
Pre-start checks
Drive board: Before assembling the machine please ensure that the drive board is of the correct
size for the machine and that its drive face is no t damaged.
Chemicals: Ensure that the floor maintenance pads that you have are suitable for the cleaning
task to be performed and that they are clean and in good condition.
Brushes: If the cleaning operation requires brushes please ensure that the brushes are clean, in
good condition and match the requirements of the machine.
Warning: This appliance has been designed for use with the brushes specified by the
manufacture. The fitting of other brushes may affect its safety.
Assembly
Tank: If the cleaning task requires a solution tank to be mounted onto the machine, you will note
that the top and the bottom of the solution tank has a tongue: these tongues should be placed into
the recesses on the black quick release tank holders mounted on the handle shaft of the machine.
The bottom tongue lies in a partially covered recess whilst the top tongue lies in a partially covered
recess which is locked into position by a securing collar. The solution feed tube can then be fed
into either side of the machine where there is a solution feed hole. The chain mechanism which
actuates the solution feed must then be assembled into the bottom left hand lever as you stand
behind the machine. Adjustments may be made to put it in its normal position with the lever in a
downward position and to make sure there is some slack in the chain so as not to hold the solution
valve open and continuously drain the solution from the tank.
Drive board and pads: Once you have selected the pad required for the cleaning task, it must be
centrally mounted on the drive board. The drive board is mounted into the machine by tilting the
machine into its transport wheels and allowing the handle to rest on the floor thus exposing the
drive mechanism. The drive board may then be centrally mounted into the drive mechanism and
locked into position by turning it anti-clockwise. This can be checked by lightly pulling on the drive
board.
Brush: If the cleaning operation requires a brush, connect the selected brush to the drive
mechanism in exactly the same way as the drive board and pad.
Operation
Main connection: Return the machine to its upright position with either pad or brush suitably
mounted on the drive mechanism of the machine. Uncoil the cable from the machine and plug it