Prior To Operation - Metabo HPT SB 3608DA Instrucciones De Seguridad Y Manual De Instrucciones

● When the pilot lamp fl ickers (at 0.2-second
intervals), check for and take out any foreign
objects in the charger's battery connector. If
there are no foreign objects, it is probable that
the battery or charger is malfunctioning. Take it
to your authorized Service Center.

PRIOR TO OPERATION

WARNING
To avoid serious accidents, ensure the switch is
in the OFF position, and pull out the battery.
1. Check the work area environment
Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
2. Power switch
Ensure that the switch is in the OFF position.
3. Installing the sanding belt
CAUTION
Use only sanding belt size specifi ed on the
product nameplate.
(1) Pull lever with fi nger, idle pulley will then move
backward.
Close lever
Idle pulley
moves back,
tensioning belt.
Idle pulley
Pull lever toward you
Idle pulley moves forward,
allowing belt to be attached.
Fig. 8
(2) Place over the drive pulley and idle pulley, passing it
over the outside of the shoe plate, and making sure
that the arrow on the inside of the belt coincides with
the corresponding mark on the tool.
Mark on the tool
Drive pulley
Arrows on the
inside of the belt
Sanding belt
(3) Push lever with fi nger, idle pulley will then move
forward and give proper tension to sanding belt.
In this case, be careful not to be hit your fi nger by
lever.
Then, adjust sanding belt position. (refer to page 17)
CAUTION
Sanding belt installed in the wrong direction will
lower work effi ciency and shorten life of sanding
belt.
4. How to remove sanding belt
Pull lever with fi nger, sanding belt will then sag and
can be taken off pulleys easily.
NOTE
○ The drive pulley and idle pulley will be hot after use.
○ Use an air blower or similar device to remove any
debris from around the pulleys with the sanding belt
removed.
5. Attaching and removing the dust bag (Fig. 10)
(1) Attaching the dust bag
Insert the dust bag into the duct on the body of the
power tool.
(2) Removing the dust bag
Hold the duct, and pull out the dust bag.
WARNING
Clean the dust bag before and after sanding metal,
and remove any sanding dust from inside. Metal
sanding dust can cause fi res.
English
Idle pulley
Shoe plate
Fig. 9
15