Tabla De Contenido; Attaching The Dust Collector - Metabo HPT SB 3608DA Instrucciones De Seguridad Y Manual De Instrucciones

English
4. How to select proper sanding belt
Choose sanding belt of proper grain size and grain
type for your specifi c purpose, by referring to Table 6
and 7 below.
Derived fi nish
Coarse fi nish
Medium fi nish
Semi fi ne fi nish
Fine fi nish
Grain type Surface to be worked on
AA Steel, Wood
WA Wood, Bamboo
○ For grain sizes, refer to Table 6.
○ Sanding belt grain should be coarser than sandpaper
used for manual work.
○ Use sanding belt of same grain size until uniform
surface is obtained. Changing grain sizes may result
in poor fi nish.
5. Switching the sander ON and OFF (Fig. 15)
The power switch is turned ON when the trigger is
pulled, and if the lock-on button is once depressed,
the power switch becomes locked, allowing
continuous operation.
The lock-on button can be released pulling the trigger.
(Fig. 15)
Never turn the power switch ON when the sander
is contacting the surface to be sanded. This is
necessary to preclude damage to the material. The
same applies when switching the power OFF.
18
Table 6
Proper grain size
30-40
40-100
80-240
180-400
Table 7
Press lock-on
button
Hold down
trigger switch
Fig. 15
6. How to work on corner
Corners can be sanded and polished by using
machine as in Fig. 16.
Side of
housing
Sanding
belt
CAUTION
● Immediately after use, always ensure that the
switch is in the OFF position and pull out the
battery.
● Since the sander may suck in dust and debris,
be careful not to place it where there is much
dust and debris when it is still spinning right
after use.
● Do not operate the tool without the sanding belt
fi tted. Doing so may damage the pulleys.

ATTACHING THE DUST COLLECTOR

WARNING
● For details on how to use the dust collector and
the type of dust that can be collected, read the
dust collector instruction manual carefully.
Attaching the elbow to the duct on the tool enables
the metabo HPT power tool dust collector to be
connected. (Fig. 17)
Duct
Adjust screw
Fig. 16
Dust collector
RP350YDH
Fig. 17