Assembly And Adjustment - DeWalt D25701 Manual Del Usuario
Ocultar thumbs
Ver también para D25701:
- Traducido de las instrucciones originales (136 páginas) ,
- Manual de instrucciones (120 páginas)
Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm
.
2
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
Conductor size (mm
)
2
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
120
- 2.0
0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
220
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Inserting and removing SDS-max
(fig. C1 & C2)
This machine uses SDS-max
(refer to the inset in fig. C2 for a cross-section of an
SDS-max
bit shank).
®
• Clean and grease the bit shank.
Only apply a slight amount of lubricant to
the bit shank. Do not apply lubricant to
the machine.
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
accessories
®
drill bits and chisels
®
• Insert the bit shank into the tool holder (8),
and press and turn the bit slightly until the sleeve
snaps into position.
• Pull on the bit to check if it is properly locked.
The hammering function requires the bit to be
able to move axially several centimetres when
locked in the tool holder.
• To remove a bit pull back the tool holder locking
sleeve (8) and pull the bit out of the tool holder.
Selecting the operating mode (fig. D1 & D2)
The tool can be used in two operating modes (fig. D1):
60
6
10
15
20
• To select the operating mode, rotate the mode
25
selector switch (7) until it points to the symbol of
-
the required mode.
-
-
6
6
6
6
15
15
20
-
Hammer drilling: for concrete, brick,
stone and masonry drilling operations.
Hammering only: for chiselling and
demolition applications. In this mode the
tool can also be used as a lever to free a
jammed drill bit.
E N G L I S H
9
Publicidad
Tabla de contenido
