Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding 1500 W,
we recommend to fit a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm
2
. When using a cable reel, always
unwind the cable completely.
Also refer to the table below.
Conductor size (mm
2
)
Cable rating (Amperes)
0.75
6
1.00
10
1.50
15
2.50
20
4.00
25
Cable length (m)
7.5
16
.
15
25
30
45
60
Voltage
Amperes
Cable rating (Amperes)
115
0 - 2.0
6
2.1 - 3.4
6
3.5 - 5.0
6
5.1 - 7.0
10
7.1 - 12.0
15
12.1 - 20.0
20
230
0 - 2.0
6
2.1 - 3.4
6
3.5 - 5.0
6
5.1 - 7.0
10
7.1 - 12.0
15
12.1 - 20.0
20
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Selecting the operating mode (fig. B)
The rotary hammer drill can be used in two
operating modes:
Rotary drilling:
for drilling into metal, wood and plastics
Hammer drilling:
simultaneous rotating and impacting for
concrete and masonry drilling and
carbide-tipped core drilling
• Select the required operating mode by
depressing the safety lock (8) and rotating the
mode selector (3) towards the symbol on the
housing until the safety lock clicks into position.
Do not select the operating mode when
the tool is running.
Inserting and removing SDS-plus
(fig. C)
Your rotary hammer drill uses SDS-plus
• Clean and grease the bit shank.
• Insert the bit shank into the tool holder (2).
• Turn the bit slightly whilst depressing the
accessory, until it clicks into position.
E N G L I S H
6
6
6
6
10
6
6
6
15
15
6
10
15
20
20
10
15
20
20
25
15
20
25
25
-
20
25
-
-
-
6
6
6
6
6
6
6
6
6
6
6
6
6
10
15
10
10
10
15
15
15
15
15
20
20
20
20
20
25
-
®
accessories
®
accessories.
en - 4
Publicidad
Capítulos
Tabla de contenido
