VONROC CS501DC Traducción Del Manual Original página 10

EN
Model No.
Battery Type
Voltage
Capacity
Recommended charger
Weight
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other
batteries could cause serious injury or damage the
tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 62841; it
may be used to compare one tool with another
and as a preliminary assessment of exposure to
vibration when using the tool for the applications
mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
signifi cantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keep-
ing your hands warm, and organizing your work
patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-4.
1. Lock-off button
2. On/Off switch
3. Laser switch
4. Auxiliary handle
5. Laser
10
6.
CD803AA
7.
Lithium-Ion
8.
20V
9.
10. Wing bolt for parallel guide
4.0 Ah
11. Handle
CD802AA
12A. Vacuum connection
0.65 kg
12B. Vacuum adapter
13. Lever for retracting lower guard
14. Upper guard
15. Clamping bolt
16. Clamping fl ange
17. Baseplate
18. Lower guard
19. Battery unlock button
20. Battery
21. Spindle lock
22. Wing bolt for depth adjustment
23. Scale for depth adjustment
24. Parallel guide
25. Laser adjustment screw
26. Battery LED indicators button
27. Battery LED indicators
28. Charger
29. Charger LED indicators
3. ASSEMBLY
Inserting the battery into the machine (Fig. B, E)
1. Insert the battery (20) into the base of the
2. Push the battery further forward until it clicks
Removing the battery from the machine (Fig. B, E)
1. Push the battery unlock button (19).
2. Pull the battery out of the machine like shown
Checking the battery charging status (Fig. F)
• To check the battery charge status, push the
Scale for bevel angle
Wing bolt for bevel angle
Cutting mark, 45°
Cutting mark, 0°
Before any work on the power tool, remove
the battery.
The battery must be charged before fi rst use.
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
machine as shown in Fig. E.
into place.
in Fig. E.
button (26) on battery shortly.
WWW.VONROC.COM